Step 13. Connecting The Power Cords - IBM Storwize V7000 Unified Quick Installation Manual

hosts, then connect the Fibre cables from your Fibre Channel switch to the
remaining node canisters Fibre Channel ports 3 and 4.

Step 13. Connecting the power cords

Connect the power cords to the power supply units.
About this task
Control enclosure:
Two power supply units are located in each enclosure. Ensure that the power
switches for the control enclosure and expansion enclosures power supply unit are
switched off.
Note: Each power supply unit comes with an attached cable retention bracket that
fastens around the power cord to prevent the cord from being removed
accidentally.
Perform the following steps when you attach the power cord to each power supply
unit:
1. Straighten the cable tie on the cable retention bracket. The cable retention
2. Open the cable retention bracket.
54
Storwize V7000 Unified: Quick Installation Guide
bracket is attached to the power supply unit.