This Figure Shows The Data Ports In The Rear Of The Control Enclosure - IBM Storwize V7000 Unified Quick Installation Manual

1
Figure 4. This figure shows the data ports in the rear of the control enclosure.
1 Fibre Channel ports. Each canister has four Fibre Channel ports. They are in
v
a block of four in two rows of two connectors. The ports are numbered 1 - 4
from left to right, top to bottom. Two ports connect to the file modules and two
are optional.
2 USB ports. Each canister has two USB ports. The ports are side by side on
v
the canister and are numbered 1 on the left and 2 on the right. One port is used
during installation.
3 Ethernet ports. Each canister has two Ethernet ports. The ports are side by
v
side on the canister. They are numbered 1 on the left and 2 on the right on the
upper canister. The port locations are inverted for the lower canister. Port 1 must
be connected first; the use of port 2 is optional.
4 Serial-attached SCSI (SAS) ports. Each canister has two SAS ports. The ports
v
are side by side on the canister. They are numbered 1 on the left and 2 on the
right. Port 1 must be connected first if you are adding one expansion enclosure.
Port 2 must be connected if you are adding a second expansion enclosure.
Note: The reference to the left and right locations applies to canister 1, which is
the upper canister. The port locations are inverted for canister 2, which is the lower
canister.
Figure 5 on page 6 shows the rear view of a model 2076-312 or a model 2076-324
control enclosure with the optional 10 Gbps Ethernet ports installed. All other
ports remain the same.
2 3 4
4 3
Chapter 1. Before you begin the installation
2 1
5