Sas Ports And Leds In Rear Of Expansion - IBM Storwize V7000 Unified Quick Installation Manual

Table of Contents

Advertisement

Figure 7. SAS ports and LEDs in rear of expansion enclosure
Each canister has two SAS ports that are numbered 1 on the left 1 and 2 on the
right 2 . Port 1 must be connected if you are adding one expansion enclosure.
Port 2 must be connected if you are adding a second expansion enclosure.
Note: The reference to the left and right locations applies to canister 1, which is
the upper canister. The port locations are inverted for canister 2, which is the lower
canister.
File module
Figure 8 on page 8 identifies the various ports and hardware in the front of the file
module:
1 VGA port
v
2 USB ports
v
3 CD drive
v
4 Control panel
v
5 Two drives
v
Each enclosure takes up the full 2U height in the rack. See the Storwize V7000
Unified Problem Determination Guide PDF on the CD for the full descriptions of the
hardware components.
1
2
2
1
Chapter 1. Before you begin the installation
7

Advertisement

Table of Contents
loading

Table of Contents