Table of Contents
Advertisement
18- FUEL TANK
1
To muffler
Filler tube
Rubber stopper
3x25mm
screw
X
To engine
Assemble the stopper and tubes as shown above. Insert the assembly clunk end first
into the fuel tank and firmly press the stopper into the neck of the tank. Align the pipes
as shown and tighten the stopper screw.
Ensure that the fuel tank clunk does not touch the rear of the tank.
19- ELECTRIC MOTOR
5mm washer...16
5x70mm.......4
5mm nut.......12
3mm screw/nut...4
1
Firewall
B
B'
B=B'
2
3x35 mm screw
4
3mm
SIDE-VIEW
114mm
(4.4")
4mm
Check the tank for leaks - block the vents and
blow into the feed, if in doubt submerse the
tank in a bowl of water, this will show up any
problems.
Install the fuel tank in the tank bay, please ensure you
pad it out well with foam to keep the tank secure and
free from vibration.
-Use your motors aluminum motor mounting plate as a
template and mark the plywood motor mount where the 4
holes are to be drilled.
-Remove the aluminum motor mounting plate and drill a
1/8"(3mm) hole through the plywood at each of the marks.
Note: The aluminum mounting plate should be supplied
with your motor, if not you will need to purchase one
2
separately.
10
Blow
Water
TOP-VIEW
A
A'
! Motor side thrust is already
built into the firewall.
A=A'
3
Advertisement
Table of Contents
