H-KING P 15B Mustang Berlin Express Instruction Manual page 11

22- ELEVATOR
Please ensure the hinges are securely
glued into place, any failure will cause a
crash.
3/8 in. (9.5mm)
Apply a thin layer of machine oil or petroleum jelly to only
the pivot point of the hinges on one elevator. Then push
the elevator and its hinges into the hinge slots in the trailing
edge of the horizontal stabilizer. Ensure you leave just a
minimal gap to avoid binding of the hinge.
When satisfied with the gap and alignment remove and
apply 5 minute epoxy the elevator hinges. Make sure to
apply a thin layer of epoxy to the top and bottom of the
hinges and to inside the hinge slots Slide the elevator
hinges back into the slots in the stabilizer leaving the small
gap as above. Repeat this process for the other elevator.
Petroleum jelly
A B
Hinge
23- TAILWHEEL
5/64 in.(2mm) I.D collar
3
1- Insert the tailwheel pushrod into the hole in the tailwheel control
horn as shown.
2- Install the tailwheel control horn to the tailwheel wire.
3- Install the tailwheel assembly as shown.
4- Secure the tailwheel control horn to the wire using a 5/64"(2mm) screw,
ensure a smooth non-binding movement.
5-
Install the tail wheel hatch (H) using 4 off 5/64x25/64"(2x10mm) self
tapping screws.
6- Attach the tail wheel doors (D) in using CA glue.
Apply 5 min.
Epoxy to both the
Control horn
top and bottom.
................3
2x12mm screw
STABILIZER
BOTTOM VIEW
2
Fit the control
horns as shown
..........6
2x10mm
screw
12
5 5
BOTTOM VIEW
6
CA
D
H
5
4
2x3mm screw 2mm I.D collar
............1
2x10mm screw
Tailwheel wire
............4
Tailwheel control-
horn
.................1
1
...............1
..........1