Table of Contents
Advertisement
29- DECALS
1- Cut out the decals and apply them to the positions shown.
2- Do not peel the backing paper off all at once. Peel off one corner of
the backing and remove with scissors.
3- Place the decal in the correct position on the model and when
with this position firmly press the corner without backing
into place.
4- Then carefully peel back the rest of the backing while at the same time
pressing the rest of the decal into place with your finger.
5- If you are unfortunate enough to get an air bubble then prick the
center of the bubble only with a pin or point of a craft knife and
carefully push the air out.
6- With any curves carefully stretch the decal and apply a little heat so
that no creases occur, cut off any excess that may occur.
Decal
Decal
IMPORTANT:
Please do not clean your model with pure alcohol, only use liquid soap with water or use glass cleaner
to clean the surface of your model.
Decal
Decal
P-51B "BERLIN EXPRESS" - VQ MODELS
All details are subject to
change without notice !
15
"Fuel Cap" Decal
Decal
VQA06BEX "Berlin Express""
Decal
Advertisement
Table of Contents
