H-KING P 15B Mustang Berlin Express Instruction Manual page 4

REQUIRED FOR OPERATION (Purchase separately)
Minimum 6 channel radio
airplane with 6-7 servos
.Motor control x1 or ESC, Elevator
x1 .Rudder x1. Aileron x2
GLUE (Purchase separately)
SILICON
Silicon sealer
TOOLS REQUIRED
Hobby knife
Needle nose pliers
Sander
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
Masking tape - Straight Edged Ruler - Pen or pencil - Rubbing alcohol - Drill and Assorted Drill Bits
If exposed to direct sunlight and/or heat, wrinkles can appear. Storing the
model in a cool place will help make the wrinkles disappear. Otherwise, remove
any wrinkles in the covering film with a hair dryer, starting with
low temperature. You can seal the edges by using a hot iron.
Symbols used throughout this instruction manual, comprise:
Drill holes using the stated
size of drill
1.5mm
(in this case 1.5 mm Ø)
A B
Use epoxy glue
Read through the manual before you begin, so you will have an overall idea of what to do.
CONVERSION TABLE
3.0mm = 1/8"
1.0mm = 3/64"
4.0mm = 5/32"
1.5mm = 1/16"
5.0mm = 13/64"
2.0mm = 5/64"
6.0mm = 15/64"
2.5mm = 3/32"
10.5x6 for .40 - 2 cycle engine
11x6 for .46
12x6 for .60
12x7 for .70
15x6 if using a 5055-430 brushless motor.
.46 ~ .50 - 2 cycle
for
Li-Po Battery, 6S 4000mAH
Silicone tube
Cyanoacrylate Glue
(Purchase separately)
Phillip screw driver
Scissors
!
Take particular care here
Apply cyano glue
CA
10mm = 13/32"
12mm = 15/32"
15mm = 19/32"
20mm = 51/64"
- 2 cycle engine
- 4 cycle engine
- 4 cycle engine
.60 ~.70 - 4 cycle
EPOXY A
EPOXY B
Hatched-in areas:
remove covering
film carefully
Assemble left and right
L/R
sides the same way.
25mm = 1"
30mm = 1-3/16"
45mm = 1-51/64"
3
2 x extension leads
for the aileron
servos. 1 x
extension if doing
the I.C. version for
the battery pack.
60-80 amp Brushless
Speed Controller
5055-430 Brushless Motor
or equivalent.
Epoxy Glue ( 5 minute type)
Epoxy Glue (30 minute type)
Hex wrench
Awl
Wire cutters
Check during assembly that these
parts move freely, without binding
Not included.
X
These parts must be
purchased separately
Low setting