Shut Down And Park; 4.12 Lifting And Tie Down; Lifting; Tie Down - JLG 450A Operation And Safety Manual

4.11 SHUT DOWN AND PARK

Shut Down and Park
The procedures to shut down and park the machine are as fol-
lows:
1. Drive machine to a reasonably well protected area.
2. Ensure boom is lowered over rear drive axle.
3. Shut down Emergency Stop at Platform Controls.
4. Shut down Emergency Stop at Ground Controls. Position
Platform/Ground Select switch to center OFF.
5. If necessary, cover Platform Controls to protect instruction
placards, warning decals, and operating controls from hos-
tile environment.
3121658
SECTION 4 - MACHINE OPERATION

4.12 LIFTING AND TIE DOWN

(See Figure 4-5.)

Lifting

1. Refer to the Serial Number Plate, refer to the Specifications
section of this manual, or weigh the individual unit to find
out the Gross Vehicle Weight.
2. Place the boom in the stowed position.
3. Remove all loose items from the machine.
4. Properly adjust the rigging to prevent damage to the
machine and so the machine remains level.

Tie Down

WHEN TRANSPORTING THE MACHINE IN THE STOWED POSITION, THE BOOM MUST BE
FULLY LOWERED INTO THE BOOM REST.
1. Place the boom in the stowed position or storage position.
2. Remove all loose items from the machine.
3. Secure the chassis and the platform using straps or chains of
adequate strength.
4-15