SECTION 3 - MACHINE CONTROLS AND INDICATORS
Platform Control Indicator Panel
(See Figure 3-10., Platform Control Indicator Panel)
NOTE:
The indicator lights will illuminate for approximately 1 second
when the key is positioned to the on position to act as a self test.
1. AC Generator (If Equipped)
Indicates the generator is in operation.
2. Platform Overload Indicator (If Equipped)
Indicates the platform has been overloaded.
3-20
3. Tilt Alarm Warning Light and Alarm
This red illuminator indicates that the chassis is
on a slope. An alarm will also sound when the
chassis is on an excessive slope and the boom
is out of transport position. If lit when boom is out of trans-
port position, lower to below horizontal then reposition
machine so that it is level before continuing operation. If the
boom is above horizontal and the machine is on a slope, the
tilt alarm warning light will illuminate and an alarm will
sound and CREEP is automatically activated.
Tilt Angle
5°
IF TILT WARNING LIGHT IS ILLUMINATED WHEN BOOM IS RAISED OR EXTENDED,
RETRACT AND LOWER TO BELOW HORIZONTAL THEN REPOSITION MACHINE SO THAT
IT IS LEVEL BEFORE EXTENDING BOOM OR RAISING BOOM ABOVE HORIZONTAL.
Market
All Markets
3121658