Step 12: Installing The Motor - Mountain Models Tantrum Instructions Manual

Attach the micro pushrod adjuster to the servo horn, but don't attach the horn to the
5.
servo yet.
Run the non-bent side of the pushrod through the micro pushrod adjuster, attach the
6.
servo horn to the servo, and then screw the servo down using the screws that came
with the servo.

Step 12: Installing the Motor

We recommend the GWS EPS300C-D for the motor. Refer to the GWS installation
instructions for more information, if necessary.
! Installing the Motor
Slide the gearbox through the motor mounts with the spinner facing forward. Make
1.
sure that it is FULLY seated.
Drill a hole through the underside of the inner cowl, through the gear box and into the
2.
motor mount.
The hole in the inner cowl should be at least 3/16" wide, so that the supplied
motor retaining screw fit. Once you get through the cowl, stop with that drill
bit and use a 1/16" drill bit to complete the hole through the gear box and
the motor mounts.
50
Mountain Models Tantrum