Connectors And Pinouts; Pinouts For Imotioncube Can; Mating Connectors - Technosoft iMOTIONCUBE BX-CAN Technical Reference

3.4

Connectors and Pinouts

3.4.1

Pinouts for iMOTIONCUBE CAN

*Remarks:
-Connector J7 is not available on previous versions of iMOTIONCUBE
-In case J7.pin1 (Earth) is not present, connect the cables Shield (if present) to GND instead.
3.4.2

Mating Connectors

Connector
Socket 2x25 pins, 1.27x1.27mm pitch, square
J1
0.40 mm pins, pass-through SMD socket
Socket 2x20 pins, 1.27x1.27mm pitch, square
J2
0.40 mm pins, pass-through SMD socket
To use full current capabilities of the drive,
solder the pins directly to the motherboard
without using socket connectors
J3
High-current socket, 8 pins, 2.54 mm pitch,
square 0.635 mm pins
- use only if needed nominal current is 8A -
To use full current capabilities of the drive,
solder the pins directly to the motherboard
without using socket connectors
J4,J5,J7
High-current socket, 2 pins (J4), 2x2 pins
(J5), 2.54 mm pitch, square 0.635 mm pins
- use only if needed nominal current is 8A -
Connector Header Through Hole 4 position
J6
0.100" (2.54mm)
 Technosoft 2019
Description Manufacturer Part Number
WPPro 6062-050-00-10-PPST
Harwin M50-3152542
Samtec CLP-125-02-F-D-BE
WPPro 6062-040-00-10-PPST
Harwin M50-3152042
Samtec CLP-120-02-F-D-BE
Samtec TSW-102-14-F-D
18
Image
iMOTIONCUBE Technical Reference