Rear And Auxiliary Brake - Linhai ATV300-D T3b Owner's/Operator's Manual

moisture from the air. This causes the boiling temperature of the
brake fluid to drop, which can lead to early brake fade and the
possibility of serious injury.
The front brake is hydraulic disc brakes which is depressing the
foot pedal (also brake lever on handlebar for 300cc ATV) on the
side of the right floorboard. These brakes are self-adjusting and
require no adjustment.
The following checks are recommended to keep the brake
system in good operating condition. How often they need
checking depends upon the type of driving that has been done.
 Keep fluid level in the master cylinder reservoirs as described
see ―7.Control and part functions‖. Normal functioning of the
diaphragm is to extend into the reservoir as fluid lever drops. If
the fluid lever is low and the diaphragm is not extended, a leak is
indicated and the diaphragm should be replaced. Always fill the
reservoir as indicated whenever the cover is loosened or
removed to insure proper diaphragm operation. Use DOT 3 brake
fluid.
 Check brake system for fluid leaks.
 Check brake for excessive travel
Or spongy feel.
 Check friction pads for wear,
damage and loosened.
 Check security and surface
condition of the disc.
 Pads should be changed when
friction material is worn to 3/64‖(1mm).(A)
16. MAINTENANCE

Rear and Auxiliary Brake

Rear Brake
The rear brake is a hydraulic disc type brake which is activated
OWNER'S/OPERATOR'S MANUAL
ATV300-D T3b
- 96 -
16.0