Oil Changing Procedure; Front Gear Case Lubrication - Linhai ATV300-D T3b Owner's/Operator's Manual

Which the ATV on the a level surface, remove fill plug and
visually inspect the lubricant level through
the fill hole(1).Lubricant should be
kept even with the center of the drill
point (2) approximately 1 5/8‖
(41mm) below the top of the fill hole.
NOTE: Do not add lubricant to the
bottom of the fill plug threads. The correct gearcase lubricant to
use is SAE 80W/90 GL5 Weight Gear Lube.

Oil Changing Procedure

1. Remove drain plug (3). Catch and
discard used oil properly.
2. Clean and reinstall the drain plug
with a new sealing washer and tighten securely (14 ft.
lbs/20N.m).
3. Remove fill plug and add 10 ounces (300ml) of SAE 80W/90
GL5. Weight Gear Lubricant and inspect oil level. Oil level
should be kept even with the center of the drill point
(approximately 1 5/8‖41mm below the top of the fill hole).
4. Reinstall the fill plug. Tight securely (14 ft. lbs/20N.m).
5. Check for leaks.
16. MAINTENANCE

Front Gear case Lubrication

With the ATV on a level surface, remove fill plug and visually
inspect the lubricant level through the fill hole. Lubricant should
OWNER'S/OPERATOR'S MANUAL
ATV300-D T3b
- 105 -
16.0