To Operate The Recoil Starter - Linhai ATV300-D T3b Owner's/Operator's Manual

The recoil starter is used to start the engine when the battery is
low ( but must more than 8 Volt).

To operate the recoil starter:

1. Grasp the starter grip
approximately 4 in (100 mm ).
2. Pull the grip up briskly and fully.
3. After the engine starts, allow the starter girp to return slowly.
CAUTION
This ATV is equipped with a recoil starter. But its engine is
equipped with a battery ignition system. If the battery is
under 8 Volt, the engine will not start.
CAUTION
Some resistance should be perceived when pulling gently the
starter cord. To start the engine, give a rapid pull at the cord,
being careful of a kickback in reverse as severe injury may result.
8.STARTING THE ENGINE
When and how to use the CHOKE
OWNER'S/OPERATOR'S MANUAL
ATV300-D T3b
firmly, when pull it out slowly
- 52 -
16.0