AUMA SA Series Operation Instructions Manual page 72

Corrective action
F4
F5
72
SA 07.2 SA 16.2/SAR 07.2
Table 32:
Secondary fuse F3 (internal 24 V DC supply)
G fuse according to IEC 60127-2/III
Size
Voltage output (power supply unit) = 24 V
Voltage output (power supply unit) = 115 V
Table 33:
Secondary fuse F4 (internal AC supply)
G fuse according to IEC 60127-2/III
Size
Voltage output (power supply unit) = 24 V
Voltage output (power supply unit) = 115 V
1) Fuse for: Switch compartment heater, reversing contactor control, PTC tripping device (at 24 V AC
only), at 115 V AC also control inputs OPEN, STOP, CLOSE
Automatic reset fuse as short-circuit protection for external 24 V DC supply for
customer (refer to wiring diagram)
Replace fuses F1/F2
Hazardous voltage!
Risk of electric shock.
Disconnect device from the mains before opening.
1. Loosen screws [1] and remove plug/socket connector [2].
Figure 75:
2. Pull fuse holder [3] out of pin carrier, open fuse cover and replace old fuses by
new ones.
SAR 16.2 Control unit: electronic (MWG)
AC 01.2 Non-Intrusive HART
F3
5 x 20 mm
2.0 A T; 250 V
2.0 A T; 250 V
1)
F4
5 x 20 mm
1.25 A T; 250 V
—
AUMA art. no.
K006.106
K006.106
AUMA art. no.
K001.184
—