AUMA SA Series Operation Instructions Manual page 47

SA 07.2 SA 16.2/SAR 07.2
AC 01.2 Non-Intrusive HART
Pivot point axis
SAR 16.2 Control unit: electronic (MWG)
Figure 51: Indication for setpoint control (positioner)
E1 Position setpoint
E2 Actual position value
The pivot points and their operation behaviour (operation profile) are shown on the
pivot point axis by means of symbols.
The symbols are only displayed if at least one of the following functions is activated:
Operation profile M0294
Timer CLOSE M0156
Timer OPEN M0206
Figure 52: Examples: on the left pivot points (intermediate positions); on the right
stepping mode
Table 24: Symbols along the pivot point axis
Symbol Pivot point (intermediate position)
with operation profile
| Pivot point without reaction
Stop during operation in direction
CLOSE
Stop during operation in direction
OPEN
Stop during operation in directions
OPEN and CLOSE
Pause for operation in direction CLOSE
Pause for operation in direction OPEN
Pause for operation in directions OPEN
and CLOSE
Multiport valve positions (S0017)
In case of active multiport valve function, the display S0017 indicates a second bar
graph with set positions (valve connections) above the actual position value E2.
Positions (P1, P2, ...) are displayed with a black triangle . Push buttons
used to select positions. Both positions and the actual position value E2 are displayed
in degrees.
Figure 53: Status indication for multiport valve (example P4 = 180°)
P (P1, P2, ...) selected position (1, 2, ...)
( ) no position selected
E2 Actual position value
Stepping mode
End of stepping mode
Start of stepping mode in direction
CLOSE
Start of stepping mode in direction
OPEN
Indications
are
47