Table of Contents
Advertisement
3.7
Options
3.7.1
Transfer Mode
Notes:
This setting may need to be changed
depending on the computer
configuration.
The setting made in this section can
be saved in the file as a preferred
setting for a particular print job.
See Section 3.3.4 for more detail.
3.7.2
Print Density
Adjustment
Notes:
The setting made in this section can
be saved in the file as a preferred
setting for a particular print job.
See Section 3.3.4 for more detail.
This section describes how to specify the transfer mode of graphics
data and make a print density adjustment.
Click the Options tab to open the Options property page.
The type of transfer mode for graphics to the printer is specified here.
Run Length Encoding is the recommended transfer mode due to its
high transfer rate. When using Uncompressed 8-bit (Overwrite), or
Uncompressed 4-bit (Overwrite), the same output as Run Length
Encoding can be obtained, but the data transfer speed slows down.
Print density needs to be adjusted to avoid blurred or light print caused
by a combination of the media with the ribbon.
Mark the Set Checkbox, and the print density for each color can be
adjusted.
The print density value can be adjusted by entering a value or by
clicking up or down arrows.
Chapter 3
Printing
57
Advertisement
Table of Contents
