A5.3 Self-Diagnostic Test - Toshiba TEC CB-416-T3-QQ Owner's Manual

A5.3 Self-Diagnostic
Test
Note:
Use the FEED or RESTART key
to select a desired option.
Notes:
If any error occurs, an error message
appears, and the printer stops
printing. After clearing the error,
press the PAUSE key to return to
"<1> DIAG.". The printer does not
restart printing automatically.
See Section A5.7.1 for the Self-
Diagnostic Test print sample and
descriptions.
Note:
See Section A5.7.2 for the Maintenance
Counter/Parameter Settings print
sample and descriptions.
The Self-Diagnostic Test contains the following:
Selection of the media sensor to be used.
Performs a Self-Diagnostic Test, and prints out the result.
Prints out the Maintenance Counter/Parameter Settings.
Checks to see if there is any problem with the print head.
<1>DIAG. V1.0
While pressing the FEED and PAUSE keys at the same time,
turn on the printer. Hold both keys until the "<1> DIAG." message
appears in the display.
Selecting the Media Sensor to be Used
SENSOR
Press the PAUSE key. The type of media sensor can be selected:
"NONE" (media positon not detected), "REFLECT." (Reflective
Sensor), or "TRANS." (Transmissive Sensor).
After selecting the media sensor to be used, press the PAUSE
key.
Performing the Self-Diagnostic Test, and Printing out the
Result
AUTO DIAGNOSTIC
The Self-Diagnostic Test is ready. Press the PAUSE key to start.
CHECKING & PRINT
The printer starts the Self-Diagnostic Test, and prints out the result.
Print out the Maintenance Counter/Parameter Settings
When the Self-Diagnostic Test result is printed, the message returns
to "<1> DIAG.". Press the PAUSE key twice.
MAINTENANCE CONT
The printer is ready to print out the Maintenance Counter/
Parameter Settings. Press the PAUSE key to start.
CHECKING & PRINT
The printer starts printing out the Maintenance Counter/Parameter
Settings.
Appendix 5
NONE
System Mode
91