Appendix 5 System Mode; A5.1 Operation Panel - Toshiba TEC CB-416-T3-QQ Owner's Manual

Appendix 5 System Mode

Important!
If System Mode is needed for any
other purposes, please contact your
authorized service representative
before performing any operation in
System Mode.

A5.1 Operation Panel

Note:
Use the RESTART key to resume
printing after a pause condition, or
after clearing an error.
88
Appenedix 5 describes usage and purposes of the keys on the
Operation Panel in System Mode.
For end users, System Mode should be used for the following five
purposes:
To perform the test print for checking print quality.
To control more than two printers by one command file.
To view the current parameter settings.
To change the character code table.
To change the control code.
The figure below illustrates the Operation Panel and key functions.
ON LINE LED
POWER LED
POWER
FEED Key
FEED
The Message Display shows messages in alphanumeric characters
and symbols to indicate the printer's status. Up to 16 characters can
be displayed on one line.
There are three LED's on the Operation Panel.
LED Illuminates when...
POWER The printer is turned on.
The printer is ready to
ON LINE print.
Any error occurs with
ERROR
the printer.
There are three keys on the Operation Panel.
PAUSE
RESTART
FEED
Appendix 5
Message Display (LCD)
ON LINE ERROR
RESTART PAUSE
RESTART Key
Flashes when...
The printer is
communicating with
your computer.
The ribbon supply is low
or in a near end condition.
To start the menus in System Mode.
To print out the test results or samples.
To enable the value or option that you
enter.
To scroll up/down the menus in System
Mode.
To select a desired value or option in
System Mode.
System Mode
ERROR LED
PAUSE Key