Feed Gap Sensor - Toshiba TEC CB-416-T3-QQ Owner's Manual

2.6.2

Feed Gap Sensor

Note:
"2" marked on the sensor indicates
the Feed Gap Sensor position.
Note:
See A1.3.2 for gap or hole specifications.
18
When the media with gaps or rectangular holes is loaded, adjust the
Feed Gap Sensor (transmissive sensor) position as follows:
1 Open the Top Cover.
2 Lift the Pinch Roller Lever to the ROLLER RELEASE position
to open the Pinch Roller Unit.
3 Align the Media Guides to width of the media.
4 Insert the media into the Media Inlet.
If the media with gaps is loaded, go to Step 5.
If the media with rectangular holes is loaded, go to Step 6.
5 Turn the Media Guide Knob, and move the media sensor so that
the gap between labels will pass under the sensor.
Media Sensor
Media Guide Knob
6 Turn the Media Guide Knob, and move the media sensor so that it
is positioned at the center of the rectangular hole.
Media Sensor
Media Guide Knob
7 The Feed Gap Sensor Position Adjustment has been completed.
Chapter 2 Printer Installation
Gap detected here
Sensor
Label
Gap
Backing Paper
Hole detected here
Sensor
Hole
Media