Table of Contents
Advertisement
14 - SPECIAL SET-UP PROCEDURE (continued)
14.2 Changing the Tape Leg Length
(from 70 to 50mm [2-3/4 to 2 inches])
The following changes to the case sealer frame and upper/lower taping heads will allow the taping of boxes
95mm [3-3/4 inch] minimum height with box widths greater than 195mm [7-3/4 inch].
Case Sealer Frame
1. Crank upper taping head frame up high enough to allow clearance for removal of lower taping heads.
2. Remove the stop bracket (Figure 14-3C) from normal position "A" and fasten in lower position "A-A".
Relocate stop brackets on both columns.
Taping Heads
•
To reduce the risk associated with sharp blade hazards:
−
Keep hands and fi ngers away from tape cutoff blades under orange blade guards.
The blades are extremely sharp.
CAUTION – Taping heads weigh approximately 7.2 kg [16 lbs]. Use proper body mechanics when
lifting or holding taping head.
3.
Lift the lower taping head, shown in Figure 14-3B, straight up to remove it from the machine bed.
4.
Refer to Manual 2, "Adjustments – Changing Tape Leg Length" for taping head set-up.
5.
Replace taping heads in case sealer, reverse of disassembly.
Figure 14-3 – Removing Taping Heads from Case Sealer
800af-I-NA
WARNING
44
2010 December
Advertisement
Table of Contents
