Table of Contents
Advertisement
13 - ADJUSTMENTS (continued)
WARNING
•
To reduce the risk associated with
pinches and entanglement hazards:
−
Do not leave the machine running
while unattended.
−
Turn the machine off when not in use.
−
Never attempt to work on any part of
the machine, load tape, or remove
jammed boxes from the machine while
the machine is running.
13.5 Gate Pressure Regulator
(Figure 13-3)
The gate air pressure is controlled by a regulator
mounted under the machine frame. This provides
adjustment of the gate lifting force. When lightweight
boxes are being run, the gate pressure can be
reduced to minimize lifting of the box.
13.6 Gate Stroke Setting
(Figure 13-4)
The machine is initially set at the maximum gate lift
of 25mm [1 inch]. This can be reduced if needed
for special situations. To do this, remove the center
roller section and turn the stop nuts clockwise until
the desired lift is achieved.
800af-I-NA
Figure 13-3 – Gate Pressure Regulator
Center Roller
Section
Figure 13-4 – Gate Stroke Setting
42
Gate
2010 December
Advertisement
Table of Contents
