Paper Size Switch
1.
Remove the Tray.
2.
Open the Top Cover.
3.
Remove the
Right Rear Cover.
4.
Remove the
Card Cage Fan Duct.
5.
Remove the
LVPS enclosure.
6.
Release the 2 hooks that secure the Paper Size Switch Holder to the frame. The four springs are attached to the
holder.
7.
Disconnect the Paper Size Switch from the Motor Driver Board connector.
8.
Release the size switch harness from the 2 cable clamps, and then carefully draw the harness into the tray cavity.
9.
Remove the Paper Size Switch and holder from the front of the tray cavity.
10.
Release the 2 hooks that secure the Paper Size Switch to the holder.
Replacement Note:
After replacement, check that the switch is aligned as shown.