Printer Motors - Oki ES3640MFP Component Replacement Manual

2.4 Printer Motors

Transfer Unit Motor
1.
Open the Top Cover.
2.
Remove the Front Door.
3.
Remove the Waste Toner Container, if installed.
4.
Remove the Left Front Cover.
5.
Position the Control Panel parallel to the floor.
6. Disconnect the motor connector.
7. Remove the 2 (metal, 6 mm) screws securing the motor.
Toner Motors
The Toner Motor supporting the YK Imaging Units is at the left. The Toner Motor supplying the CM Imaging Units
is on the right. While these motors are identical, notice that they are positioned differently on the mounting plate.
Note: A non-captive spring is located behind each Toner Motor to provide tension against the lower tab.
1. Remove the Card Cage.
2. Release the tab at the bottom of each mounting plate.
3.
Lift the motor perpendicular to the printer to release the top tab from the frame.
4.
In the case of the CM Toner Motor, release the ribbon cable from the clamp.
5. Disconnect the Toner Motor connector from the Motor Diver Board.