Basket Assembly
Note:
Take note of the Torsion Spring position before removing the Inner Shaft.
1.
Remove the
Top Cover.
2.
Remove the
Right Rear Cover.
3.
Remove the
Left Rear Cover.
4.
Remove the
Fuser Fan and Fan duct.
5.
Remove the
Job Offset Assembly.
6.
Remove the Top Output Chute.
7.
Remove 4 (Black, plastic 6 mm) screws that secure the Waste Toner manifold to the Lower Basket Assembly.
8.
Remove 3 (metal, 6 mm) screws that secure the left side Basket Assembly Support Rail to the LED Assembly.
9.
Remove 2 (metal, 6 mm) screws, and release two hooks that secure the cover to the right side Basket Assembly Support Rail.
10.
Remove 3 (metal, 6 mm) screws that secure the left side Basket Assembly Support Rail to the LED Assembly.
11.
Raise the LED Assembly completely, and then, using a small, flat-bladed screwdriver remove the 2 pins that
serve as stops at the rear of the LED Assembly.