Waste Toner Auger Rotation Sensor; Transfer Unit Belt Rotation Sensor - Oki ES3640MFP Component Replacement Manual

Waste Toner Auger Rotation Sensor

The Waste Toner Auger Rotation Sensor is located at the right end of the Waste Toner Manifold. The sensor is
connected to the Motor Driver Board.
1.
Open the Top Cover.
2. Open the Basket Assembly.
3.
Remove 1 (metal, 6 mm) screw that secures the sensor holder.
4.
Disconnect the sensor from the harness.
5.
Release 1 hook that secures the sensor in the holder.
Replacement Note:
Seat the sensor completely in the holder before securing the screw.

Transfer Unit Belt Rotation Sensor

The Transfer Unit Belt Rotation Sensor is mounted inside the Housing Bias Assembly.
1. Remove the Housing Bias Assembly.
2.
Release 2 hooks that secure the sensor to the assembly.
3.
Disconnect the sensor from the harness.