2.3 Internal Printer Components
Job Offset Assembly
Note:
There are two springs on top of the Job Offset Assembly that are not captured. Use care not to lose these springs.
1.
Remove the
Top Cover.
2.
Release the Job Offset Motor harness from the guides at the rear of the LED Assembly (4 red wires).
3.
Release 2 hooks securing the Job Offset Assembly to the Top Output Chute.
4.
Lift the assembly, and then move the front to the left to reveal the Job Offset Motor and connector at the back of
the assembly.
5.
Disconnect the Offset Motor from the harness.
6.
Remove the Job Offset Assembly.