Ptz; Alarm Server Settings Page; Table 13: Ptz Settings Page; Figure 26: Ptz Setting Page - Grandstream Networks GXV3500 User Manual

Notes:
•
Click "Save" to save the FTP configuration information.
•
Click "Test" after configuration, if setting is correct, a test FTP operation will be performed and "Test
successful!" orange bar will display if the operation is successful, like:

PTZ

This page allows user to configure PTZ parameters if the connected analogue camera support Pelco-D or
Pelco-P protocol.
Protocol
Baudrate
Address ID
Note:
•
The address ID filled here has to be same and match the one used in the connected analogue
camera. Otherwise the PTZ will not function or behave abnormal due to the wrong Pelco-D or Pelco-
P address used.

Alarm Server Settings Page

This page allows user to configure alarm HTTP server to upload alarms (Upload Alarms to VMS platform
supported or HTTP Server for processing)

Figure 26: PTZ Setting Page

Table 13: PTZ Settings page

Pull-down to select supported PTZ protocol by connected analogue camera.
Only Pelco-D or Pelco-P allowed.
The baudrate used by the analogue camera interface, select from the pull-
down menu.
Hardware Pelco-D or Pelco-P address ID used by the analogue camera,
please refer to related camera user manual for this ID (or PIN switch in the
UM), then fill in related matching address into this field.
GXV3500 User Manual
Version 1.0.3.6
P a g e | 49