Restore Factory Default Setting; Reset From Web Interface (Soft Reset); Reset Via Button (Hard Reset); Figure 35: Factory Reset From Web Interface - Grandstream Networks GXV3500 User Manual

RESTORE FACTORY DEFAULT SETTING

WARNING!
Restoring the Factory Default Setting will DELETE all configuration information of the camera. Please
BACKUP or PRINT out all the settings before approach to following steps. Grandstream will not take any
responsibility if you lose all the parameters of setting or cannot connect to your VoIP service provider.

Reset from Web Interface (Soft Reset)

This page allows user to configure dynamic network related parameters:
Note: Reset can be triggered via TELNET by using command: restore.

Reset via Button (Hard Reset)

To "hard" factory reset the camera, with the camera powered on, press and hold the "reset" button for 15
seconds until the IP camera reboot. The internal small
meaning a successful hard factory reset.
1.
3.
V_IN, BNC Interface
1.
Video Input (Voltage: 1.0V p-p; Resistance 75 Ω)
2. MIC_IN: 3.5mm socket for external 3
3. RESET: PIN hole, press & hold for 15 seconds to factory reset the device.

Figure 35: Factory Reset from Web Interface

red

Figure 36: GXV3500 Front View

: GXV3500 BNC interface, connect to analog camera as
rd party microphone input.
GXV3500 User Manual
Version 1.0.3.6
power LED will illustrate "On ➔ Off ➔ On",
2.
P a g e | 59