PTZ
This page allows user to configure PTZ parameters if the connected analogue camera support Pelco-D or
Pelco-P protocol.
Figure 20: PTZ Setting Page
Protocol:
Baudrate:
Address ID:
NOTE:
The address ID filled here has to be same and match the one used in the connected analogue
camera. Otherwise the PTZ will not function or behave abnormal due to the wrong Pelco-D or
Pelco-P address used.
Grandstream Networks, Inc.
Pull-down to select supported PTZ protocol by connected
analogue camera. Only Pelco-D or Pelco-P allowed.
The baudrate used by the analogue camera interface, select from
the pull-down menu.
Hardware Pelco-D or Pelco-P address ID used by the analogue
camera, please refer to related camera user manual for this ID
(or PIN switch in the UM), then fill in related matching address
into this field.
GXV3500 User Manual
Firmware Version 1.0.1.94
Page 47 of 82
Last Updated: 05/2016