Ddns Setting Page (Decode Mode); Table 22: Ddns Setting; Figure 40: Ddns Setting Page (Decode) - Grandstream Networks GXV3500 User Manual

Notes:
•
If camera behind SOHO router with port forwarding configuration for remote access, static IP or
static DHCP has to be used to avoid IP address change after router reboot.
•
TCP port above 5000 suggested if Port Forward HTTP for remote access, due to some ISP would
block port 80 for inbound traffic. For example, change the default HTTP port from 80 to 8088, to
make sure the TCP port not likely blocked.
•
In addition to HTTP port, RTSP port is also required to configure via port forward, so that remote
party can view the video stream.
•
If revise the default TCP port 80 to port "A", then RTSP port should be "2000+A" (changed from
default TCP 554). Both TCP port "A" and "2000+A" should be configured for port forwarding in the
router. For example, the HTTP port changed to 8088, the RTSP port now should be 10088, both
TCP ports 8088 and 10088 should be configured for port forwarding in order for remote camera
access: 8088 for web portal, 10088 for video streaming.

DDNS Setting Page (Decode Mode)

This page allows user to configure dynamic DNS related parameters:
DDNS Active
DDNS ISP Type
Self-Define DDNS Address
Site Name
DDNS Account

Figure 40: DDNS Setting Page (Decode)

Table 22: DDNS Setting

Enable DDNS by check this field.
Select the DDSN service provider from the pull-down menu list.
Input the self-defined DDNS address.
DDNS site name.
DDNS account name
GXV3500 User Manual
Version 1.0.3.6
P a g e | 65