Figure 49: Remote Alarm_Out Peering Gxv3500 Configuration - Grandstream Networks GXV3500 User Manual

Notes:
•
GXV3500 is designed to work with analogue camera, with maximum decode resolution
704x576, this is why 2
setting will be:
rtsp://IPCamera:Port/4 (4 is 2
•
2 stream also consume less bandwidth therefore good for internet transmission.
nd
•
H.264 video codec has to be selected because Motion Detection not supported via MJPEG.
•
All Grandstream IP Cameras without built-in Alarm_Out interface can peer with GXV3500
(Decode Mode) built-in Alarm_Out interface for Motion Detection Remote Alarm_Out. Alarm_Out
duration can be configured at "System" setting page of GXV3500 Decode. See below the figure.
When Alarm_Out taking action, the webpage will show the related action.
For example, below the "Digital Output Duration" is selected as "15 seconds" so the Alarm_Out will act for
15 seconds before revert back to previous state. In below case, the default is circuit "Open", when Motion
Detection alarm triggered, the circuit state changed to "Close", as illustrated below for 15 seconds and then
switch back to prevoius "Open" state.
Figure 48: Remote Alarm_Out peering GXV3500 Configuration
nd stream decoding used as peering for remote Alarm_Out. The RSTP
nd stream of GXV3672/GXV3674/GXV3610)
GXV3500 User Manual
Version 1.0.3.6
P a g e | 76