Table of Contents
Advertisement
Troubleshooting
⚠
WARNING:
Issue
The Turntable does not move when
you step on the Turntable Foot
Pedal.
The unit is not getting power.
No air comes out of the Air Hose
when you step on the Inflate Foot
Pedal.
It is difficult to secure Tires when
clamping externally.
The Pressure Gauge is not working
correctly.
The Bead Breaker does not work
correctly or works but makes
strange noises.
The Assist Arms move up and down
slowly or make odd noises when
moving.
If you continue to have problems with your Tire Changer, visit
BendPak Ranger at (805) 933-9970.
R80EX Tire Changer
Disconnect the Tire Changer from power and incoming
maintenance
. Take whatever steps are necessary to make sure the unit cannot
be re-energized while maintenance is being performed on it (such as
Lockout/Tagout). The unit uses pneumatic and electrical energy; if your organization
has Lockout/Tagout policies, make sure to implement them before troubleshooting
the Tire Changer.
Action to Take
Make sure the unit is getting power.
Have a licensed, certified Electrician check the electrical path
from the supplied cord to the power source. If any issues are
found, have them fixed. Refer to
additional information.
Make sure the unit is correctly connected to a working
incoming air source.
Use the Restraint Cone to press the Tire down so the Clamps
correctly grab the Rim of the Wheel.
Check the accuracy of the Pressure Gauge with a professional
gauge. Fix immediately if the Pressure Gauge is not working
correctly.
Review the Installation to make sure the Bead Breaker
Mechanism was installed correctly.
Grease both Assist Tower Posts. Refer to
Assist Tower Posts
for more information.
www.bendpak.com/support/
61
before performing any
Wiring Information
Grease the
P/N 5900087 — Rev. B — Jan. 2020
for
or call
Advertisement
Table of Contents
