Ranger R80EX Installation And Operation Manual page 16

Installing the Bead Breaker Mechanism
The Bead Breaker Mechanism comes assembled but not installed. This section describes how to
install it.
The Bead Breaker Mechanism attaches to the Tire Changer at multiple places:
• The Arm Pin (part of the Arm Pin Bracket Assembly) goes through the Arm Pin Hole.
• The Return Spring gets stretched out and hooks to the Return Spring Hole.
• The Cylinder Shaft gets extended and goes through the Pivot Pin.
Once the Bead Breaker Mechanism is installed, you need to attach the Blade Tension Spring between
the bottom of the Bead Breaker Mechanism and the small hole at the bottom of the Bead Breaker
Blade.
Not necessarily to scale. Not all components shown.
R80EX Tire Changer
16
P/N 5900087 — Rev. B — Jan. 2020