Table of Contents
Advertisement
Troubleshooting
⚠
WARNING:
Issue
The Turntable does not move when
you step on the Turntable Foot
Pedal.
The unit is not getting power.
No air comes out of the Air Hose
when you step on the Inflate Foot
Pedal.
It is difficult to secure Tires when
clamping externally.
The Inflation Gauge is not working
correctly.
The Assist Arms (R980 only) move
up and down slowly or make odd
noises when moving.
If you continue to have problems with your Tire Changer, visit
BendPak Ranger at (805) 933-9970.
R980 Series of Tire Changers
Disconnect the Power Cord from power and the incoming from the Air Source
before performing any maintenance
make sure the unit cannot be re-energized while maintenance is being performed
on it (such as Lockout/Tagout). The unit uses pneumatic and electrical energy; if
your organization has Lockout/Tagout policies, make sure to implement them
before troubleshooting the Tire Changer.
Action to Take
Make sure the unit is getting power.
Have a licensed, certified Electrician check the electrical path
from the supplied cord to the power source. If any issues are
found, have them repaired. Refer to
additional information.
Make sure the unit is correctly connected to a working Air
Source.
Use the Restraint Cone to press the Tire down so the Clamps
correctly grab the Rim of the Wheel.
Check the accuracy of the Inflation Gauge with a professional
gauge. Fix immediately if the Inflation Gauge is not working
correctly.
Grease the Assist Tower Post, it has run out. Refer to
Grease the Assist Tower Post
. Take whatever steps are necessary to
www.bendpak.com/support/
58
Wiring Information
for more information.
P/N 5900158 — Rev. F - March 2022
for
or call
Advertisement
Table of Contents
