Troubleshooting - Ranger R76LT Installation And Operation Manual

Troubleshooting

⚠
WARNING:
Issue
The Turntable does not move when
you step on the Turntable Foot
Pedal.
The unit is not getting power.
No air comes out when you step on
the Inflate Foot Pedal.
It is difficult to secure Tires when
clamping externally.
The Inflation Gauge is not working
correctly.
The Assist Arms (R76ATR only)
move up and down slowly or make
odd noises when moving.
If you continue to have problems with your Tire Changer, visit
BendPak Ranger at (805) 933-9970.
R76 Series of Tire Changers
Disconnect the Tire Changer from power and incoming
maintenance . Take whatever steps are necessary to make sure the unit cannot
be re-energized while maintenance is being performed on it (such as
Lockout/Tagout). The unit uses pneumatic and electrical energy; if your organization
has Lockout/Tagout policies, make sure to implement them before troubleshooting
the Tire Changer.
Action to Take
Make sure the unit is getting power.
Have a licensed, certified Electrician check the electrical path
from the supplied cord to the power source. If any issues are
found, have them fixed. Refer to
additional information.
Make sure the unit is correctly connected to a working
incoming air source.
Use the Restraint Cone to press the Tire down so the Clamps
correctly grab the Rim of the Wheel. R76ATR only.
Check the accuracy of the Inflation Gauge with a professional
gauge. Fix immediately if the Inflation Gauge is not working
correctly.
Grease the Assist Tower Post, it has run out. Refer to
Grease the Assist Tower Post
www.bendpak.com/support/
56
before performing any
Wiring Information
for more information.
P/N 5900346 — Rev. C — Dec. 2019
for
or call