Ranger R80EX Installation And Operation Manual page 18

To install the Blade Tension Spring:
1. Locate the Blade Tension Spring.
2. Slide the mostly closed end of the Spring around the threads of the Socket Head Cap Screw
between the Lock Nut and the head of the Socket Head Cap Screw.
Side view. Blade Tension Spring goes on the underside of the Bead Breaker Mechanism. Not
necessarily to scale. Not all components shown.
3. Tighten the Lock Nut down towards the Socket Head Cap Screw so that the closed end of the
Spring is secure between them.
4. Tighten the Socket Head Cap Screw into the Bead Breaker Mechanism (use a 5 mm hex key).
5. Extend the Blade Tension Spring and put the open end through the Small Hole in the Bead
Breaker Blade.
R80EX Tire Changer
18
P/N 5900087 — Rev. B — Jan. 2020