For servicing automobile and light truck single piece tires / wheels (30 pages)
Summary of Contents for Ranger GoCar RCD-1500
Page 1
1645 Lemonwood Dr. Santa Paula, CA 93060 USA Toll Free: (800) 253-2363 Tel: (805) 933-9970 rangerproducts.com GoCart™ Rolling Car Dollies Setup and Operation Manual Manual P/N 5900207 — Manual Revision B — September 2021 Models: • RCD-1500 • RCD-1500EX Model RCD-1500EX shown. Designed and engineered by BendPak Inc.
Page 2
Warranty. The BendPak Ranger warranty is more than a commitment to you: it is also a commitment to the value of your new product. For full warranty details, contact your nearest BendPak Ranger dealer or visit bendpak.com/support/warranty.
RCD-1500EX: GoCart™ Car Dollies, also referred to as Vehicle Positioning Jacks, Extended- length is ideal for larger, wider Tires, supports up to 1,500 lbs. each. More information about the full line of Ranger Products is available at rangerproducts.com. This manual is mandatory reading for all GoCart Car Dollies users ⚠...
Make a visual inspection of the product before using it. Do not use the product if you find any missing or damaged parts. Instead, take the unit out of service, then contact an authorized repair facility, your distributor, or Ranger Products at (800) 253-2363. Symbols Following are the symbols used in this manual: ⚠...
Page 5
• Use of the equipment for purposes other than those described in this manual. • Modifications to the equipment without prior, written permission from BendPak Ranger. • Injury or death caused by modifying, disabling, overriding, or removing safety features. •...
Specifications Model RCD-1500 RCD-1500EX 1,500 lbs. / 680 kg 1,500 lbs. / 680 kg Holding capacity 6,000 lbs. / 2,722 kg 6,000 lbs. / 2,722 kg Load Rating Total 12" / 305 mm 13" / 330 mm Tire Width Capacity 15 –...
Page 7
Review Final Checklist before Operation • A visual inspection should be made prior to each use of the Positioning Jacks. The inspection should check for abnormal conditions such as cracked welds, damaged or loose and missing parts or wear. • Any product that is found to be damaged or operates in an abnormal manner, must be removed from service immediately.
Operation To raise the Positioning Jack to support a Vehicle: 1. Drive the Vehicle to the desired location, set the parking brake, put the Vehicle in Park or in first gear, if it has a manual transmission. 2. Remove the Lock Pin from the Frame. 3.
Maintenance Make sure your Positioning Jacks are maintained on a regular basis. Dirt is the single greatest cause of failure in Hydraulic Systems. Keep the Positioning Jacks clean and well lubricated to prevent foreign matter from entering the system. If the Dollies have been exposed to rain or snow, sand, or grit they must be cleaned and dried before use.
Page 10
• Annually: Replace the Hydraulic Oil in the reservoir. o Oil change procedure: Check the Oil, place the Dolly on level ground and expand the Rollers apart. Remove the Oil Filler Plug. The plug is on the far side of the cylinder. See figure ...
Troubleshooting ⚠ CAUTION Repair procedures must be accomplished in a dirt-free environment by qualified personnel who are familiar with this equipment. ⚠ WARNING To prevent injury, perform maintenance, and repair procedures when the Positioning Jacks are free of a load. Trouble Cause Solution...