Self Test - Toshiba TECRA M2 User Manual

System start-up
When the computer does not start properly, check the following items:
■

Self Test

■
Power Sources
■
Power-on Password
Self test
When the computer starts up, the self test will be run automatically, and the
following will be displayed:
This message remains on the screen for a few seconds.
If the self test is successful, the computer tries to load the operating system,
depending on how the Boot Priority is set in the TOSHIBA HW Setup
program.
If any of the following conditions are present, the self test failed:
■
The computer stops and does not proceed to display information or
messages except the TOSHIBA logo.
■
Random characters appear on the screen, and the system does not
function normally.
■
The screen displays an error message.
Turn off the computer and check all cable connections. If the test fails again,
contact your dealer.
Power
When the computer is not plugged into an AC outlet, the battery pack is the
primary power source. However, your computer has a number of other
power resources, including intelligent power supply, Real Time Clock
battery. These resources are interrelated and any one could affect apparent
power problems. This section provides checklists for AC power and the
battery. If you cannot resolve a problem after following them, the cause
could lie with another power resource. In such case, contact your dealer.
Overheating power down
If the computer's internal temperature becomes too high, the computer will
automatically enter Hibernation or Resume mode and shut down.
Problem
Computer shuts down
and DC IN 15V
indicator blinks orange
TECRA M2
In Touch with Tomorrow
TOSHIBA
Procedure
Leave the computer off until the DC IN 15V
indicator stops blinking.
Troubleshooting
9-4