Parallel Printer; Security Lock - Toshiba TECRA M2 User Manual

Parallel printer

You can connect any standard Centronics-compatible parallel printer to
your computer. All you need is an IBM PC parallel printer cable. Your dealer
can supply one or you can purchase one at most computer stores.
The cable's connectors are designed so that it is impossible for you to
connect them incorrectly. You can also connect a parallel printer to an
optional Advanced Port Replicator
steps:
1. Turn off the computer.
2. Insert one end of the cable into the computer's parallel port.
3. Tighten the screws that fasten the cable connector to the computer's
4. Insert the other end of the cable into the printer's parallel connector.
5. Fasten the connector to the printer with the clips on the parallel port.
6. Turn on the printer.
7. Turn on the computer.
8. Start the HW Setup program. Refer to Chapter 7, HW Setup.
9. Select the Parallel/Printer tab from the HW Setup window.
10. Set the mode to ECP and press OK.
11. Choose Reboot for the change to take effect.

Security lock

Security locks enable you to anchor your computer and optional Advanced
Port Replicator III to a desk or other heavy object to help prevent
unauthorized removal of the computer or Advanced Port Replicator III.
The computer has a security lock slot on the left side. Attach one end of a
cable to a desk and the other end to the security lock slot.
1. Turn the computer so the right side faces you.
2. Align the holes for the security lock and attach the lock.
TECRA M2
parallel port.
III
. To connect a printer, follow these
Security lock
Optional Devices
8-22