Toshiba TECRA M2 User Manual page 97

Hibernation: When you press Fn + F4, the computer enters Hibernation. To
avoid entering Hibernation unexpectedly, a dialog box appears for
verification. However, if you select the check box, it will not appear in the
future.
Display selection: Press Fn + F5 to change the active display device. When
you press these hot keys, a dialog box appears. Only selectable devices will
be displayed. Hold down Fn and press F5 again to change the device. When
you release Fn and F5, the selected device will change. If you hold down
these hot keys for five seconds the selection will return to LCD.
LCD Display Brightness: Pressing Fn + F6 decreases the display
brightness in decrements. When you press these hot keys, the current
setting will be displayed for two seconds by an icon. You can also change
this setting through the Screen brightness item of the Basic Setup tab in
TOSHIBA Power Saver.
LCD Display Brightness: Pressing Fn + F7 increases the display brightness
in increments. When you press these hot keys, the current setting will be
displayed for two seconds by a pop-up icon. You can also change this
setting through the Screen brightness item of the Basic Setup tab in
TOSHIBA Power Saver.
.
■
The brightness level is always set at the maximum value for about
18 seconds, when the LCD turns on. After 18 seconds, the brightness
level will appear at the Power Save Mode setting or you can change it
manually.
■
Display clarity increases with the brightness level.
TECRA M2
The Keyboard
5-5