Cleaning The Computer; Disconnecting Lan Cable - Toshiba TECRA M2 User Manual

3. Plug the other end of the cable into a LAN hub connector. Check with
your LAN administrator before connecting to a hub.
When the computer is exchanging data with the LAN, the LAN Active
indicator glows orange. When the computer is connected to a LAN hub but
is not exchanging data, the Link indicator glows green.

Disconnecting LAN cable

To disconnect the LAN cable, follow the steps below.
Make sure the LAN Active indicator (orange LED) is out before you
disconnect the computer from the LAN.
1. Pinch the lever on the connector in the computer's LAN jack and pull out
the connector.
2. Disconnect the cable from the LAN hub in the same manner. Check with
your LAN administrator before disconnecting from the hub.

Cleaning the computer

To help ensure long, trouble-free operation, keep the computer free of dust
and use care with liquids around the computer.
■
Be careful not to spill liquids into the computer. If the computer does get
wet, turn the power off immediately and let the computer dry completely
before you turn it on again.
■
Clean the computer using a slightly damp (with water) cloth. You can use
glass cleaner on the display. Spray a small amount of cleaner on a soft,
clean cloth and wipe the screen gently with the cloth.
Never spray cleaner directly onto the computer or let liquid run into any part
of it. Never use harsh or caustic chemical products to clean the computer.
■
Remove the dust from the cooling vents on the Left side of the computer
regularly with vacuum cleaner. See Chapter 2, The Grand Tour, Left side.
TECRA M2
Operating Basics
4-28