Socket S700 Command Barcodes page 15

Socket User Manual (V 1.2) 2017/11/06
Transmit "No Read" Message (5Eh)
R : 00 00 05 C7 04 00 5E
W : 00 00 07 C6 04 00 FF 5E
W : 00 00 07 C6 04 00 FF 5E
Parameter Scanning (ECh)
R : 00 00 05 C7 04 00 EC
W : 00 00 07 C6 04 00 FF EC
W : 00 00 07 C6 04 00 FF EC
Parameter Pass Through (F1h 71h)
Enable Parameter Pass Through to transmit bar codes in the following format, in Code 128, to the host:
<FNC3>L<any length data>
<FNC3>B<12 characters of data>
Note that the special Code 128 character <FNC3> must appear at the beginning of this data. However, if the
appropriate data does not follow this as shown above, it does not transmit to the host device.
R : 00 00 06 C7 04 00 F1 71
W : 00 00 08 C6 04 00 FF F1 71
W : 00 00 08 C6 04 00 FF F1 71
Disable All Symbologies
S1 S2
01 S1 S2
Enable No Read ( for Trigger Mode – Level only )
00 S1 S2
*Disable No Read
S1 S2
01 S1 S2
*Enable Parameter Scanning (Enable Setup Code)
00 S1 S2
Disable Parameter Scanning (Disable Setup Code)
S1 S2
01 S1 S2
Enable Parameter Pass Through (For Code-128 only)
00 S1 S2
*Disable Parameter Pass Through (For Code-128 only)
Disable All Symbologies
15