GLP KNV Series Quick Start And Safety Manual page 40

www.glp.de
See Figure 26. Lift up the second fixture so that the
connector channels D of both fixtures are next to
each other and push a KNV Module Connector C
fully into the channels on both fixtures.
Press the Module Connector locking knob A and
twist it 90° clockwise so that the latch B engages in
the channels in both fixtures, then release the
locking knob A and check that the fixtures are
locked securely together. This procedure is shown in
shown in Figure 20 on page 35.
Continue adding KNV Line fixtures one below the
other in the same way, but do not exceed the
permitted maximum of 20 fixtures total in the
column.
Immobilize the bottom of the column so that no
lateral movement of the column is possible. If the
bottom of the column is not immobilized, any
sideways force applied to the column can cause
hardware to fail, resulting in a full or partial collapse
of the column.
C
Figure 26. Fastening KNV Lines together with a KNV Module Connector
You can also use KNV Module Connectors to fasten KNV Lines, KNV Cubes and KNV
Arcs to each other. If you mix fixtures in an installation in this way, consult the user
documentation of all the fixture types and respect all safety precautions given.
40
A
D
B
KNV Dot and Line Quick Start and Safety Manual Rev. A
Figure 25. Flying vertical
columns of KNV Lines
D
C