GLP KNV Series Quick Start And Safety Manual page 39

German Light Products®
You can use KNV Module Connectors to fasten a maximum of twenty (20) KNV Line
fixtures together in a single column that is suspended vertically from a rigging truss. The
column may consist of KNV Line fixtures fastened to each other end-to-end or side-to-
side.
To fly a vertical column consisting of up to twenty (20) KNV Lines from a rigging truss:
Obtain the following:
A Half-Coupler Rigging Clamp and a high-tensile screw or bolt to fasten the KNV
•
Rigging Connector to the rigging clamp. These items must be capable of safely
supporting the total load that will be suspended from them.
A KNV Rigging Connector.
•
Enough KNV Module Connectors (see under
•
KNV Line installation hardware starting on
page 34) to fasten the KNV Line fixtures
together in a column.
A safety cable that is approved for the total
•
load that it will secure.
Bolt the rigging clamp to the KNV Rigging
Connector.
See Figure 24. Push the KNV Rigging Connector into one of the connection
channels on the ends or sides of the KNV Line, push and twist the Connector knob
A 90° clockwise so that the latch B locks the Connector into the channel, then
release the knob A and check that the Connector is locked into the channel. The
Rigging Connector mechanism is similar to the Module Connector mechanism
shown in Figure 20 on page 35.
Lift the rigging clamp, rigging connector and KNV Line up to the truss and fasten
the clamp around the truss.
Secure this first KNV Line with an approved safety cable as described in 'Securing
with a safety cable' on page 19.
KNV Dot and Line Quick Start and Safety Manual Rev. A
A
Figure 24. KNV Rigging
Connector lock
B
39