Contents INTRODUCTION.......................3 1.1 S ....................4 AFETY ULES INSTALLATION......................4 2.1 M ......................4 OUNTING 2.2 S N ................4 ECURE THE 2.3 C .....................5 ONNECTORS 2.3.1 AC Connectors..................5 2.3.2 DMX .......................5 2.4 F ........................5 USES DMX- ADDRESSES / BASIC FUNCTIONS..............5 3.1 A DMX- A ................5 DJUST THE DDRESS...
1.1 Safety Rules N is a High-Tech Product. To guarantee a smooth operation, it is necessary to keep following rules. 1. Make sure that the mirror of the N , can move without any mechanical problems and that all fan openings are clean and not blocked by anything.
2.3 Connectors 2.3.1 AC Connectors 230/120 Volt, 50/60 Hz Please see printing on the case for the right power supply ! 2.3.2 DMX DMX 512 Standard input/output Please see printing on the case for the right Pin usage! [+] = Pin 3 / [-] = Pin 2 / [Ground] = Pin 3 N starts at the DMX- Address [001].
3.2 Special Functions 3.2.1 Reset Function After switching on the N a Reset is made automatically. While the Reset „rSt“ is shown in the display. You can make a Reset also via DMX direct from your controller. Therefore select the following DMX- adjustments. Channel 7 (Laser) DMX-Value: 240 –...
3.3.1 Switch between Master- and Receive- Mode You can switch between the Master- and Receive- Mode by holding the “Key 100” of the display while switching on the For the Master/Send- Mode you see „S-F“ (fast) or „S-S“ (slow) in the display.
3.5 Temperate Control Deviates the temperature value too much from the system standard, the lamp will turn off automatically. Reconnection can only be made by authorized dealers. German Light Production (V2.1)
5 Change the Lamp For a hassle free change of the Light bulb, it is absolutely necessary to follow all descriptions in this chapter step by step. 5.1 Safety Rules • Unplug AC power connection • Allow to cool (over 15 minutes) •...
6 Maintenance the The cleaning of the inner optical System, color filters and color correction filter should be done by qualified person only! Contact your local GLP Dealer for details. Use no strong detergents, acid etc. for cleaning the case.