GLP KNV Series Quick Start And Safety Manual page 29

German Light Products®
Continue adding KNV Dots horizontally as described above until you reach the
desired width of the array.
Secure every Dot in the top row with an approved safety cable as described in
'Securing with a safety cable' on page 19.
Add KNV Dots underneath the top row. Do not allow any column of Dots to exceed
the limit of maximum of ten (10) Dots high in total. Each time you add a Dot, fasten
it to the Dots on all sides using GLP Slide Connectors as described in 'Fastening KNV
Dots together' on page 22.
Fasten the bottom of the array to secure anchoring points so that no point in the
array can be pushed or pulled sideways. When immobilizing the bottom of the
array in this way, do not increase the load on rigging hardware by applying
downwards tension to the array.
Rigging
Clamp
13-55/45/15
GLP Half-Slide
Connector with 5/8"
(16 mm) Spigot
Figure 15. KNV Dots array, each column independently supported
KNV Dot and Line Quick Start and Safety Manual Rev. A
KNV Dot
GLP Slide
Connector
29