GLP KNV Series Quick Start And Safety Manual page 10

www.glp.de
• If a fixture or PSU is installed in a location where it may cause injury or damage if it
falls, install as directed in this manual a safety cable or similar secondary
attachment that will hold the device if a primary attachment fails. The secondary
attachment must be approved by an official body such as TÜV as a safety
attachment for the load that it secures, it must comply with EN 60598-2-17 Section
17.6.6, and it must be able to support a static suspended load that is ten times the
load that it secures.
• If a fixture or PSU is installed in a location where it may be exposed to forces such as
wind pressure, vibration or movement, make sure that the installation can withstand
these forces. Monitor weather forecasts constantly. Take down the installation
immediately if there is any risk of weather conditions that could destabilize the
installation.
• Check that all covers and items of rigging hardware are secure before using KNV
Dot and Line products. Do not operate products with missing or damaged covers,
shields or any optical component.
• Restrict access below the work area and work from a stable platform whenever
installing, servicing or moving fixtures or PSUs.
• If a KNV product becomes damaged, stop using it immediately and disconnect it
from power. Do not attempt to use a product that is obviously damaged.
• Do not modify the fixture or PSU in any way not described in its user documentation.
• Install genuine GLP parts only.
10 KNV Dot and Line Quick Start and Safety Manual Rev. A