Contents
First
Previous
Next
Previous
Page
Page
Page
View
14.5 Apply Loctite 242 to the nut, re-install and tighten lightly.
14.6 Align the wheel on the fixed leg so that it runs parallel to the leg.
14.7 Using a suitable straight line on the studio floor, check that over a distance of 3.6 m (12 feet) the
deviation does not exceed 5 cm (2 in.). Re-adjust the wheel until this is achieved. If it cannot be
achieved, the wheels on the other two legs should be re-aligned.
14.8 Once the wheels have been correctly aligned, tighten nuts (8.1).
14.9 Install foot support (7) on each leg and secure with two screws (7.1).
(7)
(7.1)
(8.1)
(8)
Fig 4.3 Skid tracking
31