Removing And Installing A Fan (Dms 1600 And Dms 3600) - Extron electronics DMS 1600 Setup Manual

2. Gently pull on the handle to loosen the power supply from the
backplane.
3. Slide the power supply out of the chassis.
4. Orient the power supply module to be installed with the LED to the
right.
5. Align the flanges on the power supply module with the left and right
power supply guides.
6.
Gently slide the power supply module into the enclosure until the
power supply meets resistance.
7.
Gently seat the power supply in the backplane.
8. Use a screwdriver to tighten the left and right knurled knobs to lock
the power supply in place. The Power LED on the new power supply
lights green.
Removing and Installing a Fan (DMS 1600 and DMS 3600)
The DMS 1600 has a single fan module. The DMS 3600 has two
identical fan modules. If a fan fails, it should be replaced at the earliest
opportunity.
The fan modules are hot-swappable; you do not need to power down the
switcher to install or remove either fan.
NOTE:
and are not field replaceable.
1. DMS 3600 only — Remove and retain the two screws
1
(
the rows of the adjacent DVI input and output connectors)
to the fan. Retain the plate.
DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Maintenance and Modifications
DMS 2000 and DMS 3200 — The fans are fixed in place
) that secure the row identification plate (identifying
1 1 1 1 1 1 1 1 1 1
FAN ASSIMBLY
1 1 1 1 1 1 1 1 1 1
29